Tag Archives: coil

How to Make Electric Stove Burner Coils Stay Level and Flat

How to Make Electric Stove Burner Coils Stay Level and FlatIf the electric coil burners on your stove won’t lie down flat, allowing you an even cooking experience, then you should remove the drip pan and ring and gently push the coil burner down into the stove cavity.

Be very careful not to Continue reading

Why does my electric stove burner no longer work?

electric stove burner coil

Find the electric stove burner coil for your stove by using your model number.

If the surface burner element on your electric stove is no longer heating, you can replace it. But first, be sure that it is in fact the burner element that is faulty and not some other part.

WARNING! Before attempting to work on any appliance, make sure that all power (electricity) and utilities (water and gas) have been turned off and/or disconnected on the appliance. Read this before you start any repair.  

One simple test – switch the element out with another that you know works (make sure it is the same size). If that element heats up, then your other element might be faulty. Use a multimeter to test the element to be sure.

Next, check the end contacts.  Are they blacked or burnt? You can try

Continue reading

Dryer Rescue

Image

Dryers are a huge upgrade from the line drying technique used for many centuries.  They have become a necessity in today’s fast paced culture. When they stop working, it can be such a hassle to get it repaired.

Our gas dryer at home stopped heating fully after the first minute or so.  After a quick call to our local repair man, he suggested to replace the burner valve coils. These often fail, preventing the dryer from heating fully because one of the coils won’t energize enough to open the gas valve.

Luckily, these are easy to replace, and generally inexpensive.

Before you begin any of this process, unplug your appliance from the electrical outlet. This is always the most important step to prevent injuries.

First (depending on your model) you have to pop off the top lid, and front panel to get to the igniter assembly.

ImageImage

On our model, we had to unscrew the bolts on the inside of the lint trap. Next, there is a switch that clicks into place when you close the top lid, this needs to be pushed back with a screw driver, or flat-ish tool, to lift the lid. Once the lid is hinged backwards, you’ll need to separate the wires running along the inside of the side panels, and front panel. You can use a screw driver here to undo the latch in the plug.

Image

After this, you need to undo another couple of screws to remove the front panel.  Then you’ll be able to get to the igniter assembly in the lower section of your dryer.

Looking at the assembly can be intimidating at first, but the part you need to replace is just sitting on top, and easily accessible.  If you can not access it easily with tools, you may need to pull out the tub.

ImageImage

Once you locate the coils, unplug the wires running to them by simply pulling on them. Undo the screws holding them in place, and pull them out. Replace them with the new ones, placing them exactly how the original ones were set in there.  Tighten the screws that hold them in place, and plug the wires back into the respective plugs.

After you make sure all screws are back in place, replace the tub, if necessary.

Image

Line up the front panel, and snap it back into place, and replace the bolts holding it in place. Make sure to reattach the wires from the side panels to the front, and finally, snap the top lid back into place, and replace the screws in the lint trap.

That’s it! (Oh, and plug your dryer back into the outlet! Don’t forget that part!)

If you need help finding the exact part for your model, give us a call, and our customer service will be happy to help you!

%d bloggers like this: